A large screen is a real investment in any home or office, and the mount is the small part that protects it. Yet many buyers make the same mistake: they choose a mount based on screen size alone, then open the box and discover that the mounting holes do not line up, that the load rating is lower than the device weight, or that the wall itself is not suitable for drilling at all. This guide walks through the criteria that should drive the decision, step by step, then reviews in-stock solutions covering the three most common situations: wall mounting, desk mounting, and a mobile floor stand.
How to choose the right mount
- The VESA pattern comes first: this is the distance in millimetres between the mounting holes on the back of the screen, measured horizontally and vertically. Common sizes are 75x75 and 100x100 for smaller displays, and 200x200, 300x300, 400x400 and 600x400 for large TVs. Measure centre to centre between two adjacent holes yourself instead of guessing, because a mount that does not match the pattern simply will not fit, no matter how right the size looks.
- Weight before size: two screens of identical size can differ noticeably in weight depending on the panel, frame and stand. Check the weight in the manual or on the box label, and pick a mount whose rated capacity sits comfortably above that figure rather than exactly on it.
- Type of movement: a fixed mount keeps the screen close to the wall for a clean look at a lower cost; a tilting mount helps when the screen sits high, reducing glare; a full-motion arm lets you swivel and extend toward other corners of the room. Keep in mind that effective load capacity drops as the arm extends further from the mounting point.
- What the wall is made of: concrete and brick walls handle direct mounting with the right screws and anchors, while plasterboard cannot carry a large TV unless it is fixed into the frame behind it. In a rented flat, a floor or desk stand is a smarter answer than drilling into the wall.
- Height and viewing angle: the practical rule is to keep the centre of the screen close to eye level when seated. Mounting high above a cabinet looks elegant but strains the neck over a long viewing session, and it needs a tilting mount to compensate for the angle.
- Cables and ventilation: leave enough space behind the device for heat to escape, plan the route for the power cable and HDMI cables before installation rather than after, and make sure the side ports stay within reach if you swap devices often.
NB P4: the straightforward answer for 32 to 55 inch screens
This universal mount covers the most common size range in homes, from a bedroom screen to a mid-sized living room TV. The word Universal means it is designed to work with more than one mounting pattern rather than being tied to a single brand, which is a practical advantage because you can carry it over to your next TV instead of buying another mount. Before ordering, check the hole pattern on the back of your set and its weight, since size alone is not enough.
NB P6: for larger screens from 40 to 80 inches
If your TV is over 55 inches you need a wider frame and a bigger mounting base that spreads the load across more of the wall. This model supports a 40 to 80 inch range, which suits spacious living rooms and small meeting rooms. At these sizes a concrete or brick wall becomes a practical requirement, and it is best to have a second person help you lift and hang the set.
ICE COOREL T1: a compact desk stand
Not every solution calls for a drill and a wall. A desk stand is a practical option if you work in a rented space or simply want a tidier desk with minimal intervention: it raises the device closer to eye level and frees the space underneath. The T1 is an economical, easy-to-set-up choice for anyone looking to organise a home desk quickly without permanent changes.
Raptor M044: a four-arm desk base
This one is aimed at serious workstations: four arms on a single base lift the screens off the desk and let you adjust each one independently. The benefit is not only cosmetic; raising the screens frees up writing space and lets you align the bezels precisely, which reduces neck strain as you move between them. It suits monitoring rooms, accounting, design work and any job that means watching several windows at once. Check the VESA pattern and the weight of each screen, since the rated capacity is shared across the arms.
Luminex HJ-8170: a floor stand for interactive displays up to 85 inches
In schools, training rooms and showrooms, drilling into the wall is often impossible or unwanted, and a single display may be used in more than one room. This is where a floor stand earns its place: a free-standing frame that carries an interactive display up to 85 inches in dark gray, giving you the freedom to move the screen and rearrange the room with no permanent mark on the building. It is also the logical answer for walls that cannot take heavy weight.
Common installation mistakes
- Going by size alone: size tells you how wide the device is, not its hole pattern or its weight, and those two are what actually decide compatibility.
- Screws that are too long: long screws can reach inside the chassis and damage it; use the length supplied with the mount, along with the plastic spacers where needed.
- Drilling without checking the wall: electrical wiring and water pipes run behind walls; stay away from the vertical runs above switches and sockets, and call a technician if you are unsure.
- Skipping arm tension adjustment: adjustable desk arms need to be calibrated to the weight of the screen, otherwise the display slowly sags or refuses to hold its position.
- Mounting without a level: a slight tilt you barely notice during installation becomes very distracting on the wall; use a spirit level and set the rail before hanging the device.
Frequently asked questions
How do I find the VESA pattern of my TV?
The simplest way is to measure it: look at the back of the set and measure, in millimetres, the horizontal distance between the centres of two adjacent holes, then the vertical distance. A result such as 200x200 is your VESA pattern. You can also check the user manual or the official specification page for your model.
Can a large TV be mounted on a plasterboard wall?
It is not advisable unless the mount is fixed into the metal or timber frame behind the board, because the board on its own will not hold heavy weight over time. If you cannot locate the frame reliably, a floor or desk stand is far safer than taking the risk.
What is the real difference between a fixed and a full-motion mount?
A fixed mount keeps the screen flush against the wall and suits a room with one clear seating position; it is cheaper and less prone to wobble. A full-motion mount lets you swivel the screen toward the kitchen or another corner, but it stands further off the wall and needs a stronger fixing.
What is the right height for mounting a TV?
Keep the centre of the screen close to your eye level while seated in your usual viewing spot. Test the height with paper or masking tape on the wall and picture the size before you drill. If you have to mount higher than that, choose a tilting mount.
When should I choose a floor or desk stand instead of a wall mount?
When you are in a rented space, when the wall is weak or full of hidden services, or when you need to move the display between rooms. A floor stand gives you the same flexibility with no permanent effect on the building.
Can I install it myself?
Desk mounts and floor stands are within reach of anyone who follows the instructions. Wall mounting a large screen, however, is best done with at least one other person, and with a technician if the wall construction is unknown.
Practical summary
Start from three numbers before anything else: screen size, weight and VESA pattern, then ask about the wall and where people sit. For home TVs up to 55 inches, NB P4 is enough; for larger sets up to 80 inches, NB P6 is the fit. On a desk, ICE COOREL T1 is the simple, economical answer, while Raptor M044 is the serious option for a four-screen setup. For halls and large interactive displays, Luminex HJ-8170 remains the most flexible solution. All of these mounts ship to every province in Iraq with cash on delivery, so you can inspect the item before you pay.
